DSS316S-UN Enclosure Quick Guide
For more information please visit our website at
www.premioinc.com
Copyright © 2017, Premio Inc. All rights reserved.
7.
Install Motherboard Components
(CPU,
heatsink, memory) using the guidelines below. For further
details, refer to the motherboard’s manual.
8.
Install IO cards
to the motherboard tray as follow:
9.
Remove the Inner Rail
from the slide rail.
1 – 2 Pull the inner rails out. Pull the blue release tab when it hits a stop.
3 – 4 Keep extending inner rail and pull the white detach tab
when it hits the second stop
5 – 6 Unretract the mid rail by pulling the latch on the mid rail
1
2
3
4
5
6
10.
Install Inner Rails
to the enclosure.
Yellow circles are for standoff screws
Secure inner rail with
M4x4L screw (red)
To remove Inner rail from unit:
Pull the latch upward and remove
the keyhole from standoff
11.
Install the Outer Rails to the Rack
as follows:
To remove slide rails, use the latches to undo the assembly as follows:
Rear Bracket
Front Bracket
12.
Install the Unit to the Rack
as follows:
For a complete instruction on how to install unit to the rack,
please follow the Slide Rail Installation Guide.
At least two people are recommended for mounting
process. Insert HDDs after unit is mounted.
13.
Drive Mapping
of DSS316S-UN is as follows:
14.
Plug in the Power Cords
to the AC
receptacles on the back of the unit.
15.
Press the Power Button
on the
front of the unit and for the system to boot up.
Left panel is for primary node, right panel is for
secondary node.
16.
Access the Serial Console
(when necessary) by
connecting RS-232 to Audio serial cable to the one of the
console ports. Use a terminal
console with baud settings 115200,
8, N, 1, N.
Refer to Enclosure Management
User’s Manual for further detail.
