Page 3
Operational Parameters
NOTICE
Do not use with water that is microbiologically unsafe or of unknown quality, without adequate
disinfection before or after the system.
Maximum
Minimum
Operating Temperature:
100°F (37.8°C)
40° F (4.4°C)
Operating Pressure:
100 psi (7.43 g/cm²)
20 psi (1.40 kg/cm²)
Contents of Whole House Filter
Please make sure all of the items listed below are contained in the box. If any of the items are missing please
contact Watts Premier at 800-752-5582 prior to installing.
Filter housing with built-in By-Pass Valve
50 Micron Sediment Filters (x3)
Filter Wrench
Whole House Filter Manual
Tools Recommended For Installation
Hacksaw or Pipe Cutter
Low Grit Sandpaper
(2) 3/4” or 1/2” Crescent Wrenches
Plumber’s Tape (also known as Thread Seal Tape)
Prior to Installation
Watts’s Whole house filter is designed to be installed on the main waterline servicing the house. It should be installed
indoors where it is not subject to cold temperatures or long term exposure to direct sunlight. Watts Inc. does not take
any responsibility for the plumbing of the system into the water line. All water filtration systems must be installed in
accordance with local plumbing codes and regulations.
NOTICE
If pipes will be sweat soldered, do not connect into the unit until the pipes have cooled.
Note: Fittings will need to be purchased for installation
Содержание WH-LD
Страница 7: ...This page intentionally left blank ...
