P-12
from the zipper edge. Move presser foot lifter(20) downward to lower presser foot.
4. Stamp foot switch (31) gently to start sewing.
5. When sewing to the zipper head, stop the sewing machine to take out the sewing texture and move
zipper head to the position sewed previously for the purpose of preventing uneven zipper head sewing.
Then continue sewing.
Sewing the other side of zipper by the same method. Pay attention to the match between two sides of
the zipper.
Reverse
Press reverse button when finishing sewing
and sew several stitches to strengthen stitches for loose
prevention, shown in the right Fig. Reverse stitches shall
not exceed 5cm. Release the reverse button and the
sewing machine will start sewing forward again.
Windind
1.Put the bobbin on the Spool Pin (22), shown in Fig 1.
2. Wind the thread of the bobbin through the clamp above winding slice (5), shown in Fig2.
3. Put the winding pin(35) shown in Fig3.
4. Insert the empty bobbin onto winding pin(35), shown in Fig4.
5. Wind the thread that passed through the clamp above winding slice (5) on the empty bobbin for
several cycles, shown in Fig5.
6.Trun “ON” power, shown in Fig6.
10. Stamp foot switch (31) to start winding, shown in Fig7
11. The empty bobbin will move to left automatically under the impact of stop block after winding full,
