P-2
General Instructions
Congratulations on the purchase of your new electric blanket.
Before first using your new appliance, it is important that you read all instructions carefully, even if you
are familiar with the appliance.
1.
Your electric blanket should be placed directly onto the mattress with the power lead near the edge
of the pillow. If using a mattress protector this goes over the electric blanket.
2.
Ensure that the electric blanket is one to suit your mattress- i.e. a Queen size electric blanket must
be used on a Queen size mattress. Do not use a Single Bed blanket on a Double, a Queen or a King
size mattress. Nor use a Double, a Queen or a King size blanket on a Single Bed mattress.
3.
Attach the blanket to the mattress as per «How to Secure Your Electric Blanket». This will keep it flat
and avoid unnecessary wear by crumpling. Then make the bed in your usual manner.
4.
Its size is such as to give even, all over warmth for the remainder of the bed surface. The blanket
should not be tucked in at the sides.
5.
When securely attached to the mattress, connect the plug to the power point and switch on. The
flexible cord and switch must be kept outside the bed and away from open windows or exposure to
moisture.
6.
It is recommended that the cord switch is set to either position ‘2’ or ‘3’ for 1 or 2 hours before going
to bed and then can be turned down to setting ‘1’ or of altogether depending on your own
requirements whilst in bed.
KEEP YOUR BLANKET FLAT AND FULLY SPREAD OUT WHEN SWITCHED ON. FAILURE TO
OBSERVE THESE INSTRUCTIONS WILL CAUSE OVERHEATING.
Heat Control
Your electric blanket is equiped with three heat control, one controller with single size electric blanket,
two controllers with doubel size electric blanket
1) Low,gentle heat
2) Medium heat
3) High heat
Overheat Protection
All Electric Blankets are fitted with our Overheat safeguard system. This offers protection against
overheating or damage to the element by disengaging the power to the heating element before any
overheat hazards occurs.
IMPORTANT
Check daily that your blanket is flat, fully spread out and secured before switching on.
FAILURE TO OBSERVE THESE INSTRUCTIONS WILL CAUSE OVERHEATING. THIS WILL
ACTIVATE OUR OVERHEAT SAFEGUARD SYSTEM, THUS LEAVING THE BLANKET
INOPERATIVE, VOIDING ALL WARRANTIES.
1. Use as an under blanket only. Not recommended for Futons or similar bedding systems.
2. This blanket is not recommended to be used on an adjustable bed, if used on an adjustable bed,
check that the blanket or cord cannot become caught or rucked.
3. Make sure that the heating area (element) on any side of the bed does not hang over the edge of the
Содержание ED-5581U
Страница 6: ......
