www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Page 4
4
3
Tighten the four (4) pre-installed M8 set screws using the supplied 5/32" Allen Key.
Small Straw or T
oothpick
Marking the 1/8”
Allowance
Small Straw
or Toothpick
Small Straw
or Toothpick
Depth Plus 1/8”
Allowance
Mark
Depth Plus 1/8”
Allowance
Mark
1)
Insert a small straw or toothpick into the threaded inserts found on the
back of the flat-panel.
2)
Use a pencil to mark the depth of the threaded insert on the small straw
or toothpick.
3)
Mark the straw or toothpick 1/8” above the depth of the threaded insert,
as shown in Figure 1.
4)
Insert the small straw or toothpick into the remaining threaded inserts
to compare and verify their depth using the straw or toothpick’s 1/8”
allowance mark.
5)
Locate the correct diameter screw for the threaded insert.
If the screw you selected is longer than the 1/8” allowance mark on
the small straw or toothpick, as shown in Figure 2 and Figure 3, do
not use this screw. The screw length must not bypass the mark.
6) Test each size of the screws provided.
The correct screws should thread easily into themounting point and
not pull out when tension is applied.
Selecting the Mounting Hardware
RTM-L
Installation Guide
