LOCK-IT™ Security System
Page 2
Installation Instructions
LOCK-IT™
Security System
NOTE
:
To utilize the LOCK-IT™ Security System, all M6 x 12mm
Phillips Pan Head screws (A) must be removed prior to
installing the M6 x 12mm Security Screws (D).
1.
Remove all pre-installed M6 x 12mm Phillips Pan Head screws
(
A
- 6 total).
2.
Use the M5 Security Wrench (
B
- supplied) to install and tighten the
M6 x 12mm Security Screws (D).
3.
Using the security wrench (supplied), remove the M6 x 8mm standard
set screw and replace it with the M6 x 8mm security set screw (
C
).
4.
Insert the nylon washer (G), 1/4” flat washer (H) and the M6 x 12mm
Security Screw (D) into the pivot point (I).
5.
Attach bracket to projector using security screws.
6.
Once the Phillips Pan Head screws have been replaced with the
security screws, re-attach the bracket (
E
) to the mount (
F
).
7.
Insert the four tilt adjustment security screws (two per side).
8.
Follow the instructions in the PDS Manual to complete the installation.
Premier Mounts
3130 E. Miraloma Ave.
Anaheim, CA 92806
Phone: (800) 368-9700 Fax: (800) 832-4888
[email protected] www.mounts.com
Mounting Bracket Security Screws
1.
Using a security wrench (supplied), secure the PDS-017 mounting
bracket using four (4) M4 x 10mm Security Head screws. Do not over
tighten these screws. Overtightening the screws may result in damaging
the threaded inserts on the projector.
