www.mounts.com | North America 800.368.9700 | Interna1-714-632-7100
Step 1. With the projector secured in the mount and power on and signal supplied to the projector you can now proceed with the final height,
tilt, roll and yaw to optimize the projected image.
Final Adjustments
A
The height can be adjusted by rotating the PBC
clockwise (higher) / counterclockwise (lower).
Once the height is achieved, tighten the
locking set screw using the supplied Security Allen
Wrench.
B
To adjust the tilt angle of the projector, slightly
loosen the side M8 screws and tilt to the desired
angle and firmly tighten the two M8 adjustments
screws.
C
If roll adjustment is needed to square the images
on the screen, slightly loosen the front and rear
M8 screws and adjust to the desired angle. The
firmly tighten the two M8 adjustment screws.
Re-check the hardware for tightness and security
Figure 7
. Final Adjustments
A
Wooden Stud
Ceiling Structure
Locking Set Screw
C
B
Wooden Stud
Ceiling
Structure
(Roll) Adjusting
Screws
NOTE: A minimum of 4 full rotation.
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
PBC-UM SERIES
