Page 1
Installation Instructions
Installation Instructions
9531-000-011-00
Parts List
MM-A1
Articulating Mounting Arm
(Qty 1)
The MM-A1 is a single articulating multimonitor mount arm that works
with any 2” tube. The mounting head provides 90° of omnidirectional
tilt. and include both 75x75mm and 100x100mm VESA mounting
patterns.The arm includes integrated cable management tabs to keep
wires and cables protected and organized.
Step 1
1.
Slide your mounting arm over the pole and base (Figure 1)
(not included, but should be installed).
Determine the position on the pole desired for your mounting arm.
2. Once in desired position,tighten the two (2)
pre-intalled M8 x 6mm set screws in the
holes in the back of the MM-A1. Tighten
with included allen key (Figure 2).
Step 2
M4 x 10mm
Combo Screws
(Qty 4)
Introduction
MM-A1
Figure 1
(Figure 3)
Are you installing to a 75x75mm or
100x100mm VESA moutning pattern?
For 75x75mm, use mounting points A. For
100x100mm use points B in figure 3.
1)
Thread the M4 screws to one-half of their
length into the top two mounting holes on
your display, but do not tighten the M4
screws at this time.
Step 3
(Figure 2)
A
A
A
A
B
B
B
B
Thread Insert in Flat
Panel or Adapter Plate
M4 Screw Partially
Threaded Into Flat Panel
Keyhole Slot
MM-A1 Mount
1)
Insert the heads of the M4 screws through the keyhole slots on the
mounting head (Figure 5).
2)
Insert the remaining two (2) M4x10mm screws, into the bottom mounting
points (Figure 4)
3)
Tighten all M4 screws.
Do not overtighten the mounting hardware
(Figure 4)
Figure 5
M6 Allen Key
(Qty 1)
Socket Wrench
(Qty 1)
Step 3
To adjust the tension and/or tilt angle of the mounting head:
1)
Adjust the mounting head by utilizing the 90
°
continuous tilt, until it is in the
desired position.
2)
Remove the side and bottom cosmetic cap from the mounting
head (Figure 6)
3)
Use the supplied socket wrench to tighten both nuts.
4)
The side nut secures the tilt position (Point A), while the bottom nut
secures the pivot (Point B).
Do not overtighten the mounting hardware
A
B
(Figure 6)
Bottom View
5/32” Allen Key
(Qty 1)
3100 E. Miraloma Avenue, Anaheim, CA 92806 | 800.368.9700 USA | F 800.832.4888 |
www.mounts.com
Unit 3, The Moorings Business Park, Channel Way | Longford, Conventry, CV6 6RH, UK |
+44 (0) 2476 644105 | F +44 (0) 2476 644165
