A
PCM Mount Brackets
L/R
B
Hardware See
Chart
C
Nylon Spacers (SP)
See Chart
D
CTM Wall Plate
1
E
5/16" Lag Bolts
6
F
5/16" Flat Washers
6
G
6 mm x 12 mm Securing Knobs
2
H
6mm x 12 mm Securing Screws
2 (TFS ONLY)
BRAND MODEL # MP HARDWARE PACK
CTM-600
Note: When the display brackets receiving slots are fully installed into the upper and lower wall plate steel rods
and the plasma is on its flat position, there is a 7/8" gap from the top of the rod to the end of the hook. This
feature is to compensate for tilting.
Note: Arrows on the wall brackets must
be facing up prior to installation. Secure
the lag bolts into the center of the wood
stud.
Note: If using the CTM with a floor
stand or ceiling mount adapter
use the (4.5") to secure the plate.
Make sure you use the correct
mounting hardware that comes
with the stand or ceiling adapter
unit. To secure the plates install
the two (2) M6 x 12 (mm) Phillip
security-screw behind the CTM
plate.
Sharp
LC-30HV2U
5,6
(4) M4 x 16 (4) 5 (mm) X 10 (mm) (4) M4 x 30 (mm) (4) 1"
Nylon spacers
Pack 17
