AM225
AM225
Page 8
Visit the Premier Mounts website at http://www.premiermounts.com
Installation Instructions
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 9
The supplied
5
/
16
˝
concrete wedge anchors must be
used for concrete installation.
You will need a
5
/
16
˝
concrete drill bit, which is
available at your closest hardware store.
Concrete Installation
Installing the Wall Frame (cont’d)
Two people are recommended for this step; one
person to level the wall frame and another person
to mark the mounting locations.
Place the wall frame against the wall in the desired
viewing location.
Level the wall frame.
Use a pencil and mark 2 upper and 2 lower
mounting locations where you will be drilling holes
for the concrete wedge anchors. Each horizontal
location cannot be closer than 12
˝
apart.
Set the wall frame to one side in a safe location.
Step 1
Use a power drill and
5
/
16
˝
concrete drill bit to drill a hole
at each of the marks.
Step 2
Step 7
Insert one (1)
5
/
16
˝
x 3
˝
lag bolt and one (1)
5
/
16
˝
washer
into each pilot hole.
The wide mounting slots in the wall frame allow lateral
shift to help you precisely position the pullout mount.
Tighten all lag bolts using a socket wrench and ½
˝
socket.
Do not overtighten the lag bolts when attaching the
mount to the wall. Improper installation may result in
personal injury or property damage.
Proceed to the
“Installing the Mounting Bracket”
section.
Example of
5
/
16
˝
Concrete Drill Bit (not Included)
Concrete Wedge Anchors (not included)
>12”
Insert a concrete wedge anchor into each hole.
If necessary, lightly tap each concrete wedge anchor
into place with a hammer.
Remove the nuts and washers from all four (4)
concrete wedge anchors.
Step 3
Place the wall frame against the wall over the
threaded shafts of the concrete wedge anchors.
Replace the washers which you removed from
the concrete wedge anchors with the
5
/
16
˝
washers
shown in the parts list on Page 3.
Attach the nuts and
5
/
16
˝
washers to each of the
concrete wedge anchors and tighten using a socket
wrench and an M10 socket.
The wide mounting slots in the wall frame allow
lateral shift to help you precisely position the
pullout mount.
Do not overtighten the wedge anchor nuts.
Step 4
Installing the Wall Frame (cont’d)
