Rear Panel Functions
1.
A/C Input
- Connects the amplifier to A/C power via the power cord supplied. Unless otherwise
specified, your amplifier is designed to operate on 120 volts A/C, 60 cycles.
2.
Fuse
- See Fuse Chart
3.
AC Power Switch
- Turns power on.
.
4.
Speaker Output Jacks
-
Multiple impedance ¼” jacks for speaker hookup.
NEVER OPERATE
YOUR AMPLIFIER WITHOUT A PROPER SPEAKER LOAD CONNECTED.
Be sure to match
the impedance of your cabinet with the impedance (output) of the amplifier.
5.
Effects Loop
- The effects loop is a passive insertion point. Any effects inserted into loop will
be run in series after the preamp and before the power section. Any effect should have buffers on
the input and output section to correctly match the signal leaving and coming back. The Master
volume controls how much signal is sent to the send.
Effect Send
- Use this jack to send the amplifiers signal to outboard effects
Effect Return
- Use this jack to connect the output of your effects to the amplifier.
6.
OverDrive Switch
- Enables Overdrive
7.
Tone Boost Switch
- Enables Tone Boost. The Tone Boost is a secondary EQ setting that
increases gain and mid-range. It will affect the control aspect of the Tone Controls. This can be
used on both Clean and Overdrive Channels.
8.
Tremolo Switch
- Enables Tremolo
9.
S/N
- Your serial number is located here. We strongly suggest that you record this number and
have it handy in case you need service, or in the event that your amp is lost, stolen, or damaged.
10
. Footswitch Jack
- The footswitch connects here. Uses a 4 pin XLR style cable. The
clean/overdrive, tone boost, and tremolo functions can be activated via the footswitch. The
Switches need to be in the down position for the footswitch to operate properly.
Содержание Two-Rock
Страница 1: ...OWNERS MANUAL...
Страница 10: ......
