E. ASSEMBLY INSTRUCTIONS
Unpack the electric parasol heater and make sure that all items are
complete.
Step 1:
Slide the pole clamp part (B) from mounting core. Place the
Heater mounting core (A) on a Pole with diameter between 35-60 mm.
Step 2:
Slip the pole clamp part (B) and fit it to the mounting core (A)
from the bottom up.
Step 3:
Fasten the pole clamp screw until the pole & firmly tightened
with the parasol heater..
Step 4:
Before operate the heater, please ensure that all three arms are
fully lifted and secured. To do this, lift each arm by holding the small
end handle and lift until a ‘click’ is heard and the arm is horizontal and
fully locked.
Step 1
Step 2
Step 3
Step 4a
Step 4b
Step 5
Step 5:
When you have finished
using the heater, allow each of the
arms to cool down sufficiently
before touching. Beware, as these
will still be hot for a while after
operation. Then, whilst holding the
arm with one hand, press the
fold
lock button
as shown in the
diagram with the other hand and
gently lower each arm to a vertical
position.
IMPORTANT
: DO NOT ATTEMPT TO FORCE THE ARMS DOWN
WITHOUT PRESSING THE
FOLD LOCK BUTTON
AS THIS COULD
RESULT IN SERIOUS DAMAGE.
F. OPERATING INSTRUCTIONS
Check the household voltage to ensure it matches the units rating plate
specification before operating. Plug into a power supply (220-240V~
50Hz) that is located in a safe,
dry area.
1.
The switch on the heater centre piece is used to control the
heating tubes
ON/OFF
. Press ‘I’ on to turn single tube ON; press
‘II’ on to turn two tubes ON. Press ‘
I
” &”
II
” on to turn three tubes
ON
.
Note: Each heating tube is 650W.
2.
Although this electric parasol heater is splash proof, do not use
when raining or in wet conditions.
3.
Always unplug from the electrical outlet, when the heater is not in
use.
G. MAINTENANCE
WARNING: Unplug, disconnect the heater from the power supply and
remove from the parasol pole (reverse step from ASSEMBLY
INSTRUCTION), before attempting any maintenance work.
•
Dampen a clean cloth with water and use on the exterior of the unit
to remove any dust or dirt.
•
Never use detergents, corrosive elements, solvents or any
chemicals to clean this product.
