Prem-I-Air EH1924, Быстрый старт, Страница: 10 / 12

STORAGE
For long term storage (more than a few weeks) it is best to clean the unit and dry it out completely:
1. Unplug the unit and remove exhaust hose and window kit.
2. Drain the remaining water from the unit
3. Clean the filter and let the filter dry completely
4. Collect the power cord at the water tank
5. Re-install the filter in its position
6. The unit must be kept in upright position when in storage
7. To preserve the unit, keep in a dry, well ventilated space indoors.
Note: the evaporator has to be completely dried out to avoid component damage and mould. Unplug the unit and
leave in a dry open area for a few days to completely dry it out.
TROUBLESHOOTING
Symptom Inspection Solution
The unit is not operating.

Check the power connection in
securely
.

Insert the power cord securely into the wall
Outlet.

Check if the water level indicator
lights up?

Empty the drain pan by remove the rubber
plug.

Check the room temperature.

The range of operating temperature is 5-
35
℃
.
The unit works with
reduced capacity.

Check the air filter for dirt.

Clean the air filter as necessary.

Check if the air duct is blocked.

To clear the obstacle.

Check if the room door or window is
open.

Keep the door and windows closed.

Check if the desired operating mode
is selected and the temperature is
properly set.

Set the mode and temperature at proper set-
point according the manual.

The exhaust hose is detached.

Make sure the exhaust hose is securely
attached.
Water Leakage

Overflow while moving the unit.

Empty the water tank before transport.

Check if the drain hose is kinked or
bends.

Straighten the hose to avoid a trap existing.
Excessive Noise

Check if the unit is securely
positioned.

Place the unit on horizontal and firm ground.

Check if any loose, vibrating parts.

Secure and tight the parts.

Noise sounds like water flowing.

Noise comes from flowing refrigerant. This is
normal.
Error
Codes
E0

Communication faults between main
PCB and display PCB.

Check the wire harness of the display PCB for
damage.
E1

Ambient temperature sensor failure

Check connection or replace it. To clean or
replace the temperature sensor.
E2

Coil temperature sensor failures.

Check connection or replace it. To clean or
replace the temperature sensor.
Ft

Condensate water high level alarm.

Empty the drain pan by removal the rubber
plug.