OPERATION
Cooling mode
•
After the machine turns on, the default mode is ‘cooling’ with the temperature set at 22
℃
and the fan speed on low.
•
Press “MODE” to select cooling mode, the cooling mode indicator light turns on.
•
Press “UP” or “DOWN” to adjust the desired temperature (16
℃
to 31
℃
).
•
Press “FAN” to select high or low fan speed.
•
Press “Swing” to oscillate the air from side to side.
Fan mode
•
Press “MODE” to select fan mode, fan mode indicator turns on.
•
Press “FAN” to select high speed or low speed.
•
In this mode Temperature and Sleep function have no effect.
Timer mode
•
Under standby mode, press “TIMER” to setup the power-on time. Use the Up/Down buttons
to set the number of hours till the unit turns on. The timer indicator turns on.
•
Under power-on mode, press “TIMER” to setup power-off timer. Use the Up/Down
buttons to set the number of hours till the unit turns off. The timer indicator turns on.
Dehumidifying mode
•
Press “MODE” button to select dehumidifying mode, dehumidifying mode indicator turns on.
•
Under dehumidifying mode, sleep function cannot be setup and the fan speed is set to low.
Sleeping mode
•
Press the “SLEEP” button to enter sleep mode, the default value of the fan speed is low.
•
When sleep mode is on and the unit is in cooling mode, after one hour the set temperature
will go up 1
℃
, after the second hour the set temperature will go up another 1
℃
and then
continue at this temperature.
•
The sleep function is disabled in dehumidifying and fan modes. If the water full indicator
lights, the machine is put in standby or the mode is changed the sleep mode will be cancelled.
Compressor protection
•
To protect the unit from unnecessary wear the compressor will only turn on three minutes
after power on or restart and it will continue to run for 3 minutes after power off. DO NOT
unplug the unit till the compressor has stopped.
Water Drainage
This air conditioner has an auto-water-evaporating system. Condensed-water is transferred to the
hot exhaust air and vented through the hose. This will not only improve cooling efficiency, but also
save energy.
If inner water tank does become full, “W.F.” will flash on the display and the Water Full LED will
illuminate. At the same time the machine will enter standby mode and a buzzer will be heard. The
compressor will stop and no keys can be pressed on the display until the internal tank has been
emptied.
To empty the water tank, switch the unit off by pressing the Power button, wait for three minutes
then disconnect from the mains supply. Place a drainage pan underneath the drain pipe (at the
bottom, rear of the unit in the center). Remove the drain cap and withdraw the bung, allow the
water to drain into the drainage pan. Replace the bung and cap then reconnect the unit to the mains
supply.
In very humid environments it is possible the tank may fill more frequently, under these
circumstances it may be easier to fit a continuous drain. To do this attach a suitable pipe to the drain
port and run to drain.