Prem-I-Air EH1524, Руководство пользователя и инструкция по установке

Страница: 7 / 16

Page 7
MAINTENANCE
Before cleaning, turn the heater off, and disconnect from the mains supply. The
heater may then be cleaned using a damp cloth with a drop of washing-up liquid
to remove any dust or dirt from the case. Do no use stronger detergents or
solvents as these may damage the plastic.
Using a dry 1" (25mm) paint-brush, remove any dust from the grilles.
If the mains lead is damaged, it must be replaced by the manufacturer or and
authorised service centre.
If the mains plug needs to be replaced, proceed as follows:
Connect the brown wire to the terminal
labelled "L".
Connect the blue wire to the terminal
labelled "N".
Connect the green/yellow wire to the
terminal labelled with the earth symbol or
"E".
Make sure that the cord-grip is positioned
correctly (over the outer sheath of the
cable) and it fully tightened.
FAULT-FINDING
The EH1524 has an overheat protection switch, which disconnects the power if
the element gets too hot. The usual reason for this is because the air-flow has
been obstructed, or the grilles have been blocked. If the heater ceases to
operate, leave it for 20 minutes to cool down, then check that the grilles are not
being obstructed.
Switch back on, and check that the unit is operating normally. If not, contact an
authorised service agent for repair.
DISPOSAL AND RECYCLING
You must not dispose of this appliance with domestic household waste.
Most local authorities have specific collection system for appliances and disposal
is free of charge to the end-user.
When replacing an existing appliance with a similar new appliance your retailer
may take the old appliance for disposal.