•
Connect the brown wire to the
terminal labelled "L".
•
Connect the blue wire to the
terminal labelled "N".
•
Connect the green/yellow wire
to the terminal labelled with the
earth symbol or "E".
•
Make sure that the cord-grip is
positioned correctly (over the
outer sheath of the cable) and it
fully tightened.
OPERATING COSTS
At time of going to press, the average cost of electricity is
£0.12 per unit (kilowatt-hour). The amount you are being
charged will be shown on your electricity bill.
At this cost, the EH1436 will cost 10p per hour to run on the
"low heat " setting, 15p per hour to run on the "medium heat"
setting, and 23p per hour to run on the "high heat" setting
with the thermostat set to its maximum.
If the thermostat is used to regulate the temperature the
operating costs will be lower, depending on the room
temperature. Use of the turbo fan makes very little difference
to the operating cost.
FAULT-FINDING
The appliance has an overheat protection switch, which
disconnects the power if the element gets too hot. The usual
reason for this is because the air-flow has been obstructed,
or the grilles have been blocked. If the heater ceases to
operate, leave it for 20 minutes to cool down, then check that
the grilles are not being obstructed.
Switch back on, and check that the unit is operating normally.
If not, contact an authorised service agent for repair.
Page 7
