PARTS DESCRIPTION
PRE-OPERATING INSTRUCTIONS
1.
Carefully remover your heater from the box.
(please save the carton for off-season storage).
2. Do
not
use
without
casters
fitted.
3.
When operating, the distance between the radiator and the wall and any
other objects must be a minimum of 20cm
4.
Make sure the unit is in the off position before plugging the heater into
the power socket and unwind the power cord from the cord bracket.
5.
Place the heater on firm level surface in the upright position.
6.
Avoid overloading the circuit. Do not use other high wattage
appliances in the same power socket. Never use a multi-point adaptor in
conjunction with this appliance.
Caution:
Do not cover or use to dry clothes.
The surface of this radiator is hot when in operation.
CASTOR ASSEMBLY INSTRUCTIONS
Do not operate the heater without the castors attached to the bottom of
the unit.
Parts: 4 castors, 2 metal axles, 2 U shaped metal brackets, 4 bolts, 2
wing nuts
1.
Fit the castors to the metal axles, by screwing in and securing with the
enclosed bolts. The flat side is the top of the axel (fig 1).
2.
Turn the radiator upside down and lean against yourself to ensure it does
not fall over (fig 2).
3.
Fit front U shaped metal bracket onto the back of the front fin, by hooking
it over the bottom of the fin (fig 3) and hold in place.
Metal Axle
4.
Turn one of the metal axels upside down and fit the U shaped metal
bracket, which is now on the unit through the holes on the axel (fig 4).
One side hooks into place and the other side is threaded. Secure the
threaded side in place with one of the wing nuts.
Castors
5.
Repeat the same assembly instructions to fit the back castors (fig 5).
6.
Check all nuts are secured tightly and turn the unit carefully back to it’s
upright position.
OPERATING INSTRUCTIONS
Caution: This is heater is hot while in operation. It should not be
operated unless it is placed in an upright position. Remove all
packaging material from the heater.
1. Select an indoor location for the heater away from electrical power cords,
curtains and other furnishing. DO not place the heater directly beneath an
electrical outlet or against paperboard or low-density fibreboard.
2. Push the power switch to off and turn the thermostat to low before
plugging in the radiator.
3. Plug the heater into the power sockets and push the power switch to on.
4.
There are two indicator light switches, which allow you to set your desired
power levels. For example on C309: ‘I’ is for 800W, ‘II’ is for 1200W. To
set the third power setting, 2000W, press both switches (II & I).
