2
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user
of the product for future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any signs
of damage. If the product is damaged, DO NOT use it, and contact your
supplier immediately.
INSTALLATION
For free-standing use:
Remove the screw that attaches the two halves
of the case together that is located between the first and second slots
from each end. Attach the feet to the underneath of the heater using the
four 12mm (½") screws. One screw in each foot goes through the hole
from where the case screw has been removed.
To wall-mount:
Referring to the diagram opposite, draw two horizontal
lines on the wall 255 mm (10") apart, the lower line more than 50 mm (2")
from the floor.
•
On the upper line, drill holes 238 mm (9½") from the centre line, using a
6 mm (¼") masonry bit, and insert a wall plug.
•
On the lower line, drill holes 263 mm (10½") from the centre line using a
6 mm (¼") masonry bit, and insert a wall-plug.
•
Fix the two hook-brackets to the upper holes using the 30 mm (1¼")
screws.
•
Fix the two L-shaped brackets to the underside of the heater between
the first and second sets of slots, using the 12 mm (½") screws
•
Hang the heater on the hook-brackets using the two 25 mm (1") slots.
•
The L-shaped brackets will now line up with the lower holes in the wall.
Attach to the wall using the other two 30 mm (1¼") screws.
