Pregis AirSpeed Ascent, Руководство оператора

Страница: 21 / 22

AirSpeed
®
Ascent Operator Manual Tech Service Hotline: 886-904-6979 Original Instruction s
November 2020
Copyright Pregis Corporation 15
All Rights Reserved
6.2 Clearing Jams
In the event the machine jams, first break the web. Then, attempt to advance the material through the
machine with the
Jog button. If the jam persists, power off the machine. Attempt to remove the
jammed material with your hands by pulling the film backwards, opposite to the feed direction. Do
not remove the safety covers. Do not attempt to cut away material.
If the jam persists, call Technical Services.
6.3 Other Items
Depending on machine settings, material production may be less than optimal. Refer to the following
to rectify the most common issues.
6.3.1 Wrinkled Seal
If the material leaves the machine with a large wrinkle in the seal – specifically in the cross-machine
direction – ensure the roll of material is properly seated on the spindle. The inner core should be
seated against the flange on the spindle. Decreasing machine temperature/fill may also remedy this
issue. See
Figure 8 in Section 4.2.
If the problem persists, call Technical Services.
6.3.2 Jamming at Startup
When loading material through the machine, ensure that the film is jogged all the way through.
See
Section 4.2.1.
If the problem persists, call Technical Services.
6.3.3 Popping Seal Section
If the machine fills pillows to the point where pillows burst, turn down Air Level. See Section 5.4.
If the problem persists, call Technical Services.
6.3.4 Pillow Pops Off Air Tube
In the event a pillow comes off the air tube before being sealed, gets punctured by the air tube, or get
lodged and breaks a perforation, ensure the roll of material is properly seated on the Spindle. The
inner core should be seated against the flange on the spindle. See
Figure 8 in Section 4.2 .
If the problem persists, call Technical Services.