Precor UBK 615, Сборка и обслуживание: Руководство

Страница: 78 / 104

24
Assembling and Maintaining the UBK 615 Upright Exercise Bike
Installing the Upright Support and Cables
DANGER
Do not attempt to connect electrical power until
all assembly procedures are complete and the
console is properly installed.
Before you begin this procedure, retrieve the cables for the
console that you plan to install on this exercise bike, or for any
Cardio Theater® equipment that you plan to install on the
console.
Note: You will need the help of another person to complete
this procedure.
To install the upright support and prepare the cables for
connection to the console:
1. Remove the wire tie holding the base unit data cable in
place inside the upright support channel.
2. Proceed according to whether or not you are installing
Cardio Theater equipment on the console.
If ... Then ...
You are not installing Cardio Theater
equipment on the console
Skip to step 5.
You are installing Cardio Theater equipment
on the console
Continue with
step 3.
3. Feed the lower ends of the following cables through the
opening just above the front stabilizer:
 Television cable

Power cable
4. Using the wire tie you removed in step 1, bind together the
upper ends of all cables.
Note: A fish tape can be helpful in the following step.
5. Place the upright support on the floor with its lower end
next to the body assembly. Thread the cable or cables
upward through the support, then use the wire tie to
secure the upper connectors of the cables at the top of
the support.
Note: In the following step, do not remove the extra serial
number label from its backing.
6. Remove the extra serial number label from the upright
support channel on the body assembly. Set the label
aside; you will be attaching it later in the installation.