Precor TRM10/GEN06, Руководство по обслуживанию

Страница: 11 / 149

© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 9
This section provides a method of checking the treadmill operation. Check
the treadmill operation at the end of a maintenance procedure and when it
is necessary to ensure that the treadmill is operating properly.
In This Section
Operation Verification ............................ 9
Operation Verification Checklist .................. 11
Operation Verification
Procedure
1
Plug the power cord into the wall outlet and then switch the circuit
breaker to the "
ON " position.
2
Press and hold the reset key for at least 6 seconds, if errors are
present the error log will be displayed. Make note of all the errors
in the error log and odometer reading for which the error occurred.
The odometer in the error log can help you determine age and relevance
of the error.
3
Clear the error log.
4
Enter the Hardware Validation test by entering Diagnostic mode as
follows:
5
Press either the STOP , PAUSE or RESET buttons and then enter
5,1,7,6,5,7,6,1
6
Select and run the Display Test , the Keypad Test , and the Heart Rate
Test. Verify the following results.

LEDs light

Keys all function

Heart rate is acquired and displayed
7
Enter the Machine Tests (submenu) and run the Belt Speed test and the
Incline test , verify following results:

Running belt spins and is controlled from 0.1mph to 16.0mph.

Lift goes up and down and the A/D value is approximately 6000+/-500
at 0% incline)
8
Press the reset key to exit diagnostics.
9
Operate the treadmill in the Manual program. Adjust the speed of the
running belt to 2–3mph. Operate the treadmill for at least 5 minutes
while walking on the unit.
Section 4 - Operation Verification