©2019 Precor Inc. | Seated Calf Extension RSL 623 | Assembly Guide
9
Route the Cable
Image
Hardware
Instructions
1
Tools: Hex wrench, 10 mm
Socket wrench, 19 mm
At front of main frame, under seat guide rod, remove hardware and
pulley.
2
Feed cable under pulley and through pulley slot.
3
Tools: Hex wrench, 10 mm
Socket wrench, 19 mm
Replace pulley and hardware from
step 1
.
4
Tool: Open end wrench, 19 mm
Route cable around pulley on pivot arm and connect to rod end
on front of main frame . Hold the rod end and fully tighten the nut.
Maximum distance is
25 mm
.
5
1 pulle
y, 4-inch cover, front
1 pulley, 4-inch cover, back
2 CRPH screws M4 x 32 mm
Tool: Philips screwdriver
Attach covers to pulley on pivot arm.
6
Tools: Hex wrench, 8 mm
Hex wrench, 4 mm
To route the cable around the lower pulley on the weight stack tower,
remove the cable retainer. Route the cable around the pulley and then
replace the cable retainer.
7
Tools: Hex wrench, 8 mm
Open-end wrench, 19 mm
Torque wrench
To route the cable to the upper pulleys of weight stack tower, remove
the cable retainers, route the cables, and replace the retainers.
Tight-
en to 50 ft-lb (67 N-m) of torque.
36
29
30
3
1
1
29
3
30
36
