page 28
C
O
M
M
E
R
C
I
A
L
P
R
O
D
U
C
T
S
D
I
V
I
S
I
O
N
Take the following steps to adjust the running belt on the C964i treadmill. To
ensure proper safety while aligning the running belt, all adjustments must be
made when the treadmill is OFF.
CAUTION: Do not walk on the running belt during this procedure.
1.
Make sure the treadmill is OFF and the running belt is completely stopped.
2.
Locate the belt adjustment bolt at the rear of the treadmill. (It is on the right
hand side as you stand behind the rear roller and face the display.) The
direction you turn the bolt depends on how the belt is tracking. Make all belt
adjustments on the rear corner bolt using the hex key provided.
•
If the belt is off center to the LEFT, turn the adjusting bolt 1/4 turn clockwise,
which moves the running belt to the right.
•
If the belt tracks off center to the RIGHT, turn the bolt 1/4 turn counterclock-
wise; this moves the belt to the left.
Important: Do not turn the adjusting bolt more than 1/4 turn at a time.
Overtightening the bolt can damage the treadmill.
3.
With the safety switch positioned at the green dot, turn ON the treadmill.
Press the QUICK START key and then increase the speed of the running
belt to 2 mph (3.2 kph) using the SPEED key.
4.
Observe the running belt for about a minute. The belt should track centered
on the running bed.
5.
Press STOP/PAUSE to stop the running belt.
6.
If the belt needs additional alignment, repeat steps 1 through 5 of this
procedure until the belt is properly aligned.
7.
Once the running belt is properly aligned, press RESET to display the initial
start-up prompt.
