PRECITEC Lasermatic LightCutter, Руководство по эксплуатации

Страница: 55 / 82

5 Maintenance
D 159195 © Precitec GmbH & Co. KG • EN 09/2019
5 - 45
5.5.1 Replacing the protective window
Fig. 5-4 Maintenance: Protective window
(protective window cartridge)
Removing the protective window
Cleaning the protective window
Installing the protective window
Attention – Clean workplace!
Only carry out any maintenance and replacement work on the protective
window in a clean workplace.
1 Clamping ring 2 Protective window
LC-
BA-oOg
2
1
1. Put the cartridge on a clean pad.
2.
Carefully remove the clamping ring (1) from the protective window frame
(cartridge) and remove the protective window (2).

Clean the protective window (2) using a cleaning pad soaked in methanol. Then
blow away any dirt with clean air
(bellows blower) .
Repeat until it is clean.
If the protective window can no longer be cleaned or if it is damaged, it must be
replaced.
1. Carefully insert the clean (new) protective window into the protective window
frame
(cartridge) .
2. Put the clamping ring (1) onto the protective window (2).
Note:
Always keep the cartridge (with protective window installed) in a horizontal position
when carrying it.
You will find the order number for the protective window in the Tab. 8-4
„Appendix: Parts available“ , page 8-67 .