PRECITEC Lasermatic LightCutter, Руководство по эксплуатации

Страница: 45 / 82

4 Commissioning
D 159195 © Precitec GmbH & Co. KG • EN 09/2019
4 - 35
4.2 Adjusting the laser beam
4.2.1 Centring and adjusting the laser beam
Centring elements
Fig. 4-1 Commissioning: Laser beam - Beam position
Attention – Laser power!
Please note the laser or machine manufacturer's adjustment instructions and
use the sample recommended by him for system setup
(commissioning)
.
Set the laser power recommended by the laser or machine manufacturer.
Prior to commissioning, the laser head
must
be checked to ensure that it is
firmly connected and does not have any play.
When adjusting the laser beam position, the system must not be under
pressure
(no cutting gas)
and the distance controller must be switched off.
Attention – Laser beam not adjusted correctly!
Care must be taken when centring the optics. If the laser beam is not adjusted
correctly, parts of the laser head can be destroyed during laser cutting.
1 Adjusting screw, A 3 Allen key
(size 2 mm)
2 Adjusting screw, B 4 Nozzle
DE
good bad
1
2
3
4
Laser beam position
A
B
(size 2)
LC-KA-oTCP