4
1. Secure with A 1/4” x 3/4” HH Bolt, 1/4”
Washer & 1/4” Nylock Nut
2.Secure with a 1/4” x 1.75” HH Bolt
&
1/4” NyLock Nut
3.Secure with a 1/4” x 2.5” HH Bolt, 2 Each 1/4” Flat Washers
, 2 each 1/4” NyLock Nuts.
See Insert
1/4” x 2.5” HH
Bolt
1/4” Flat Washer
1/4” Nylock Nut
Assembly Instructions
Maximum operating weight—130 lbs.
Tools Required for Assembly
Minimum
(2) 1/2” Wrenches
(2) 7/16” Wrench
(1)Hammer
Assembly Note: Loosely tighten nuts and bolts first. Fully tighten when the spreader is
completely assembled.
5
Applying Product
1. Set Flow Rate
Calculate or find the rate setting for the
product being spread. See the calculation
chart on the next page.
With control lever in the off position, press
down on the calibration indicator button
and slide it to desired setting number.
2. Fill the Hopper
With the spreader control lever in the off
position, fill the spreader over a patch of
bare ground or sidewalk/driveway.
DO NOT
fill the spreader on the lawn.
Sweep up any spilled product.
3. Apply
While unit is in motion at approximately 3
miles per hour, push spreader control lever
up to calibration indicator button to release
product.
Application Tips
For rectangular lawns,
apply two header strips
at each end of the lawn and then go back and
forth between the header strips. Close spreader at
the end of each pass and reopen at the start of
next pass.
For irregular-shaped lawns,
apply one header
strip around the entire lawn, and then go back and
forth.
To avoid streaks or misses, slightly overlap each
strip over the edge of the previous strip.
Use the settings under “Standard Settings” Section
for most applications by figuring lbs. per 1000
square feet.
These numbers are for a one pass application.
A two pass application is recommended, using a
crisscross pattern. If using this method, us half the
setting number given.
If you think too much is being applied, cut down
your setting. The solution for too much fertilizer is
water.
Close Spreader at the end of each pass. Open
again at the start of your next pass.
Over Lap
Broadcast Spreader Application Chart
Fully Open Position
Adjustable Hex
Head Nuts
Move handle on the Number Pad all the way open.
Check to see if Slide Plate on Hopper slides to the
fully opened position. If not, adjust using the two
1/4” nuts that the Rod is Attached with.
