PD2-6262 Helios Large Display Analog Dual-Input Rate/Totalizer Instruction Manual
35
Setting the Display Parameter & Intensity (
dsplay
)
The main display (
line 1
) can be programmed to display:
1. Ch-A rate (
D Ch-A
)
2. Ch-B rate (
D Ch-B
)
3. Ch-C math channel (
D Ch-C
)
4. Toggle Ch-A & Ch-B rate (
D AB
)
5. Toggle Ch-A rate and Ch-C (
D AC
)
6. Toggle Ch-B rate and Ch-C (
D BC
)
7. Toggle Ch-A & Ch-B rate, and Ch-C (
D ABC
)
8. Ch-A total (
D T-A
)
9. Ch-B total (
D T-B
)
10. Ch-A grand total (
D GT-A
)
11. Ch-B grand total (
D GT-B
)
12. Toggle Ch-A rate and total (
D RT-A
)
13. Toggle Ch-B rate and total (
D RT-B
)
14. Toggle Ch-A rate and grand total (
DRGT-A
)
15. Toggle Ch-B rate and grand total (
DRGT-B
)
16. Relay set points (1-8) (
DSET 1
to
DSET 8
)
17. Max, min, and max & min values for
Ch-A, Ch-B, or Ch-C (
D Hi-A
to
d HL-C
)
18. Toggle Ch-A rate & units (
d A-u
)
19. Toggle Ch-B rate & units (
d B-u
)
20. Toggle Ch-C & units (
d C-u
)
21. Toggle Ch-A total & units (
d TA-u
)
22. Toggle Ch-B total & units (
d TB-u
)
23. Toggle Ch-A total and Ch-B total (
d tAb
)
24.
Toggle Ch-A total, Ch-B total, and the sum of total A and total B (
d tABC
).
Notes: The sum of total A and B for t ABC is independent of channel C programming. Channel C
may be used normally by a different display selection even when
D tABC
is selected for one of
the two displays.
25. Modbus input (
nm bus
)
The small display (
Line 2
) can be programmed to display:
1. All options for the upper display
2. Off, with no display (
d ofF
)
3. Engineering units for any single channel, total, or grand total
Display Intensity:
The meter has eight display intensity levels to give the best performance under
various lighting conditions. Select intensity 8 for outdoor applications. The default intensity setting is 8.
After setting up the input and display, press the Menu button to exit programming and skip the rest of the
setup menu.
The displays can be set up to read channels A, B, or C, toggle between A & B, B & C, A & C, A & B & C,
toggle between channels A, B, or C & units, the max/min of any of the channels, including the math
channel (C), set points, gross (without tare) or net (with tare) & gross values of channel A or B, or the
Modbus input. In addition to the parameters available on the Upper display, the Lower display can display
Engineering units or it could be turned off.
