PD8-6060 Explosion-Proof Dual Analog Input Process Meter
Instruction Manual
24
Mounting
The ProtEX-MAX has four slotted mounting flanges
that may be used for pipe mounting or wall mounting.
Refer to
•
Do not attempt to loosen or remove flange bolts
while the meter is in service.
Mounting Dimensions
All units: inches (mm)
Figure 1. Enclosure Dimensions
– Front View
Figure 2. Enclosure Dimensions
–
Side Cross Section View
Wall Mounting Instructions
The meter can be mounted to any wall or flat surface
using the four provided mounting holes located in the
cast-in flanges. In addition, the internal electronic
assembly can be rotated to allow the enclosure to be
mounted in any position. To mount the meter to a
wall, follow these instructions:
•
Prepare a section of wall approximately 7" x 8.5"
(178 mm x 216 mm) for meter mounting by
marking with a pencil the mounting holes (shown
in
) on the wall.
•
Select the appropriate mounting screws for the
mounting surface to be used. The mounting holes
diameter is shown on
Note:
Mounting screws are not included.
•
Using a drill bit slightly smaller than the girth of
the mounting screws, pre-drill holes at the
mounting locations previously marked.
•
Insert mounting screws into the four mounting
holes and screw them into the pre-drilled holes.
