PRAIRIE PRECISION NETWORK
CELL SIGNAL TESTER 2018
5
SURECAL CELL SIGNAL TESTER GUIDE
SETUP
POWER & CHARGING
The power switch is used to turn on/off the device. The power supply interface is a mini
USB interface. You can plug the AC power supply or any power source marked DC5V
into it. Make sure that the power source can provide over 1 amp of current.The charging
light is a green LED. When it is plugged in and the power switch is OFF, the LED will
continue to blink while it is being charged. If the AAA batteries are fully charged, the
LED will blink once. When the charging is finished, the LED will stay lit.
ANTENNA USE & INSTALLATION
The included antenna is used to pick up an outside RF wireless signal to determine its
strengths and weaknesses of each band to determine an ideal location to install outside
antennas, for example. To attach, screw antenna jack clockwise at top of meter.
Antenna Interface uses the included high gain antenna with SMA cable connector to
gauge the best outside RF wireless signal for installing or adjusting a directional
outside antenna.
Step 1: Attach the SMA end of the antenna jack on the top of the signal meter.
WARNING: Attaching the cable connectors from the meter to a cellular
amplifier can permanently damage your signal meter. If you wish to
measure signal from the meter to amplifier, contact tech support at
[email protected] to find out how.
