PRADA NARGESA MX340G, Инструкция

Страница: 14 / 42

INSTRUCTIONS BOOK OF HYDRAULIC PRESS MX340G 13
5.4. Working at manual mode
In this mode,follow the steps described next: Press the pedal to make the punching operation.Then you will
see on the LCD screen that the meter of the machine has been increased in one unit.
Picture 16. Information of the Manual Punching operation
In
picture 16, you can see how the meter marks 1 punching operation now. Once that punching operation
has been completed,you may get your foot off the pedal.
You must keep in mind that this mode of performance permits the piston rod descend bit by bit as you are
pressing the pedal longer or not. When the lower route end is reached or when you raise your foot off the
pedal, the rod movement stops.
According to this way of performance, you may adjust the Lower route end to graduate the the going down
of the rod while you press the pedal and so you will be able to see how the machine keeps on descending
until the afored mentioned route end is reached.
Finally, it is important to remind that in this mode of performance the rod of the machine never goes in as-
cending direction, so in case you need it to go up, you should proceed as detailed in the following section.
5.5. Working at automatic mode
In order to go from MANUAL working mode to AUTOMATIC working mode, just press the AUTOMATIC
key . In doing so, the machine will ask you a confirmation and we press the AUTO key again. Then
the rod will activate going up. Such movement won’t stop until the machine has reached the Upper End
route. Except for that the AUTOMATIC mode is quite similar to the one described in the
section 5.4 .
However, we will point out below some of the differences we find:
Press the pedal to make the punching operation. Then you will see the meter of the machine increased in
one unit.
Picture 17. Information of the Automatic punching operation
In picture 17, you can see how the meter has increased again when pressing the pedal and now it is indica-
ting a 2. Once this operation has been finished, you may leave your foot off the pedal. Nevertheless in this
working mode, unlike in the other one, the piston rod will come back again to the rest position when it will
start up the going up movement until the lower end route is activated.
MANUAL
CNT: 1
AUTOMATIC
CNT: 2