13/18
LED INDICATION
On
DMX signal OK
Off
No DMX signal
Green
Flash
DMX signal error
Yellow On
Setting the panel
Blue On
Power
Red
Slave mode or Running self test mode
Red/Green
Green
Master mode
MAINTENANCE
To prolong the life of the projector, some maintenance work has to be done to ensure the LED optical system in good
condition. If the projector does not function, check the fuses on the power socket of the projector, they should only be
replaced by fuses of the same specification. Should these be damaged, call a qualified technician before replacement.
The projector has thermal protection device that will switch off the projector in case of overheating.Should either of these
operate, check that the fans are not blocked, and if they are dirty, clean them before switching on the projector again.
Check that the fans are operational, if not, call a qualified technician.
Any maintenance work should only be carried out by qualified technicians.
KEEPING THE PROJECTOR CLEAN
To ensure the reliability of the projector, it should be kept clean. It is recommended that the fans should be cleaned
every 15 days. LED lens should also be regularly cleaned to maintain an optimum light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoke or particularly dirty
surroundings can cause greater accumulation of dirt on the unit’s optics. A soft cloth and typical glass cleaning products
should be used for cleaning. It is recommended to clean the external optics at least once every 20 days.
Do not use any organic solvent, e.g. alcohol, to clean housing of the apparatus.
TROUBLESHOOTING
PROBLEM ACTION
The projector doesn’t switch on
¾
Check the fuse on the power socket.
The lamp comes on but the projector
doesn’t respond to the controller
¾
Make sure that the projector is correctly configurated.
¾
Replace or repair the DMX cable.
The beam appears dim
¾
Check that the optics is clean.
