4/12
INSTALL THE LIGHTING FIXTURE
When the lighting fixture is used, as the right figure above, unfold the support to certain angle and put the lighting fixture onto a
flat surface. Make sure it is steady.
When the lighting fixture is used at a high place, as the left figure above, fold the support, turn it round to the top of the lighting
fixture, connect a lamp hook to the mounting hole reserved in the support by screws, and then hang the hook to a high place.
Eventually, use the safety cord provided to pass through the handles and hang it as a second safety fixing.
CONTROL SYSTEM AND POWER CONNECTION
Connection between the controller and a lighting fixture and between one lighting fixture and another must be made with a 2
core-screened cable, with each core having at least a 0.5mm diameter. Please use the lighting fixture’s cannon 5- pin signal input and
output cables as connection. The 5-pin signal connections are connected as shown in the figure above.
Note: Care should be taken to ensure that none of the pins touch the metallic body of the plug or each other. The body of the plug is not
connected in any way. The device accepts digital control signals in protocol DMX512 (1990).
As for power connections, each lighting fixture has to be supplied separately by external power. Use the power cord of each lighting
fixture to connect the mains power directly, making sure the voltage and frequency marked on the panel of the lighting fixture match
what is supplied.
