6
Take 2 clamps and 1 safety cords out from the package and mount 2 clamps on the underside of fixture with 4 retainers attached to
each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the
WARNING
on the underside of
the base as shown above) Always ensure that the projector is firmly anchored to avoid vibration and slipping whilst functioning.
Always ensure that the structure that you are going to mount the projector is secure and is strong enough to support the weight of the
fixture.
WARNING:
●
The projector MUST be lifted or carried by the HANDLES instead of clamps.
●
.For safety the safety cord should afford 10 times the Projector’s weight.
●
.For safety, it should not be hung by its sides.
●
POWER CONNECTIONS
Connect the power cord as follows:
L (live) =brown
E (earth) =yellow/green
N (neutral) =blue
Before power connection, please ensure the power supplied must match what the nameplate says. It is recommended that each
projector be connected with power separately so that they may be individually switched on and off.
●
The earth wire(yellow/green) must be connected to the ground. And electrical connection must be in
accordance with the standards concerned.
●
If any questions about the electrical installation, do not continue but consult a qualified electrician.
●
The lighting fixture is with waterproof power socket, it should be equipped with same IP rating power
plug.
CLAMP
SAFETY
CORD
WARMING
Please run safety cord
through 2 safety holes for
safety
