PR Lighting Theatre Master PR-3010, Руководство пользователя

Страница: 4 / 12

4/12
Theatre Master manual.doc
This unit has been designed to be hung. Mount the bracket provided on the body of the projector via 2
locking knobs, then suspend the projector via its bracket using a M12 size bolt and a nut. When you
want to adjust the angle of the body of the projector, you only loosen the 2 locking knobs carefully and
then adjust the angle of the body. After finishing that, it is recommended that you don’
t forget to
retighten the two knobs. Always ensure that the projector is firmly positioned to avoid vibration and
slipping, and always ensure that the structure to which you are attaching the projector is secure and is
able to support a weight of 23Kg for each Theatre Master.
Remove the cover by undoing a M4 knurled screw.
Insert the lamp in the lamp-holder, and ensure the little bubble on the lamp is at a right angle (90°) to
the beam path. Keep the lamp clean during installation.
Reinstall the cover and tighten the M4 knurled screw.
NOTE: The HMI series are high pressure lamps with external igniters ( ). Care should always be
taken when handling these lamps. Always read the manufacturers "Instructions for use" enclosed with
the lamp.
The unit is supplied with a power cord. Should any other connections be required they must be carried
out with the following configuration.
Earth = Green/Yellow cord
Neutral = Blue cord
Neutral = Brown cord
When the power is switched on, the apparatus automatically starts to run the programmes of self test.
After finishing these, the apparatus is ready for operation.
SETUP OPTIONS
To set the setup options, press the DIP switchs with the 6
numbers as shown below.
No. 1 switch ON, colours rainbow effect enable
No. 1 switch OFF, colours rainbow effect disable
No. 2 switch ON, colours flowing enable
No. 2 switch OFF, colours flowing disable
No. 3 switch ON, shutter function enable when colours changing
No. 3 switch OFF, shutter function disable when colours changing
No. 4 switch: Not used
No. 5 switch: Not used
No. 6 switch: Not used
FITTING THE LAMP
OPERATION
INSTALLING THE PROJECTOR
POWER CONNECTIONS