5/22
3.
INSTALLATION
●
RIGGING
Before moving a projector, Please lock Pan and Tilt. Before its operation, please unlock them. It’s forbidden to run a
projector with power while it is locked
Take 2 clamps and the safety cord out from the package and mount 2 clamps on the underside of fixture with 2 retainers attached
to each clamp. Hang the fixture on the structure and fasten the screws attached to each clamp. (See the
WARNING
on the
underside of the base as shown above)
To pass the SAFETY CORD through the HOLES for safety!
Always ensure that the
projector is firmly anchored to avoid vibration and slipping whilst functioning. Always ensure that the structure that you are going
to mount the projector to is secure and strong enough to support the weight of a XR 1000 Framing
●
PACKAGING
To avoid damaging or deforming the lens plate before packaging, please follow the instructions below: If the fixture needs to be
packaged, before packaging, it should be powered-on to make the lens plate at the lowest position; the top of the lens plate must not be
higher than the top of the head cover, otherwise, the lens plate will be damaged and malfunction. Please note it!!
Note
: Because the LED product consumes high power and the top end of its mixing rod is convex surface being very hot if the
light is on, the mixing rod’s surface must be very clean without any dirt. If it is dirty, please clean it in time, otherwise the dirt on the
surface will absorb much heat, resulting in the mixing rod being burned. Please note it!!
Safety Cord
Damp
Handle
Control Menu
please run the safety cord
through the two holes for
safety.
