8
5.
SETUP AND CONFIGURATION
●
FRONT PANEL OPERATION
The configuration and start address can be set conveniently via push button and color touch screen.
To view or change its setup, touch any white area of the screen or push the key OK for more than 3 seconds to unlock the
display(While only on battery, push OK key). After the unlocking, push
► key t
o enter into function menus. Each main menu has its
submenus and each submenu has a specific function. For details, please see the “OPERATION MENU” with following
the 6
th
point..
1.
In the page of function setup, push any key of
◄, ►, ▲ and ▼ or icon for the function desired.
2.
At 2
nd
,3
rd
and 4
th
level menus, key
◄ means ESCAPE, key ► won’t function, key OK means ENTER. Push key OK to
save any changes o enter into submenus. Push key ▲or ▼ to change numbers(plus or minus) or tap any item required
for changes.
Push the left key or shortcut key X to go back to the upper level menu. If none pushed, the system will go back to initial display
automatically.
Shortcut keys: after the interface of FUNCTION MENU, the upper part is with menus for many functions. On the right, there are 4
shortcut keys, which are
←,→,lamp control or English/Chinese menus.
●
DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The projector has 3 DMX modes. There are short mode ,standard mode and extended mode. For example standard mode
has 46
c
hannels, so set the No. 1 projector’s address 001, No. 2 projector’s address 047, No. 3 projector’s address 093, No. 4
projector’s address139, and so on.
Launch the projector. Press key OK
more than 3seconds to unlock the display. After the unlocking, push key
► to enter into menus.
After selecting the sign of DMX setting, push OK key or tap the screen directly and select DMX address at 2
nd
level menus.
Push key
▲ or▼ or tap sign < or > to set the number desired.
Push
OK key
to confirm.
Push key
◄ and
it will return to the upper menu
.
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1.
Enter into the projector’s menu. Select the menu “Config Settigns” via the keys of
▲ and ▼
OK
