6
●
LUBRICATION
To ensure smooth movement of gobos and zoom and focus lens, it’s advised rotators’ bearings and 2 sliding bars for zoom and focus
lens be lubricated every 2 months. High quality and high temperature lubricant/grease is advised..
●
TROUBLESHOOTING
PROBLEM
ACTION
A projector can’t be switched on
Check if the fuse is burned
Check if the power cord is connected well
Check if the switching power supply is bad or not connected well. A
professional technician is required for the repair
Check if the control board is connected well. .A professional technician
is required for the repair
A projector can be switched on , but the LED
lamp’s brightness can’t be controlled
Check if the LED driver board is connected well. A professional
technician is required for the repair
A projector can be switched on normally, but not
controlled by the DMX controller
Make sure that its start address is right
Replace or repair the XLR signal cable.
The beam is not bright and its brightness
decreases sharply
Make sure the fans are working well or fans and their shields are not blocked
by dust.
Make sure that the internal optics are clean.
A project image appears to have a halo
Carefully clean the LED lamp, optical lenses and other components.
Heavily Defective Beam
Check if lens are in good condition(not cracked)
Clean dust or grease on the lens.
3.
INSTALLATION
●
PLACED ON A FLAT SURFACE
While placing a projector on a flat surface, tighten the head after loosening its screw and adjusting its angle till desired. For the version
with wireless control, while it is on a flat surface its antenna should face upward.
NOTE
It’s advised to use hexagon screws coupled with anti-slipping
washers to ensure firm installation. Whatever screws may be used,
they should not be less than 2 pairs.
