PR Lighting PR-2927, Руководство пользователя

Страница: 8 / 28

8
●
Don’t touch the internal surface of the reflector and the burner of the lamp with bare hands so as not to
impair the beam output. While lamp’s installation, do not damage the metal wire around the burner.
●
Please read "Instructions " enclosed with the lamp
●
Do operate the projector while adjusting the lamp
●
GOBO /COLOR FILTER REPLACEMENT
Lock the tilt and loosen the 6 fast-fit screws on the upper cover ,After removing the cover, you will see the structures as the figure
below.
Before replacing a gobo on the fixed gobo wheel, use your finger to remove the spring tightening it and take the old one out with due
care. At last put the new into the wheel.
To replace a gobo on the rotating gobo wheel: take the rotator from the wheel, take the gobo out from the rotator by removing the
tightening spring. Put the new gobo back to the rotator, then tighten it with the spring. Please ensure the spring is in the narrow
location of the rotator, which is the internal ring of it and flatten it. At last, pull up the spring strip using proper tool and put the rotator
back to the wheel with the assistance by another hand.
Note: Do not touch the glass gobo with bare hand. Place clean and soft paper or cloth between hand and glass gobos.
Tighten 6 fast-fit screws after the cover is on. Unlock the tilt.
DANGER!
Before replacement of gobos, the projector must be off the power.
5. SETUP AND CONFIGURATION
●FRONT PANEL OPERATION
Fixed gobo wheel
Rotating gobo wheel
Framing module