DMX TERMINATOR
In the Controller mode, at the last fixture in the chain, the DMX output has to be connected with a DMX terminator. This
prevents electrical noise from disturbing and corrupting the DMX control signals.
The DMX terminator is simply an XLR connector with a 120
Ω
(ohm) resistor connected across pins 2 and 3, which is
then plugged into the output socket on the last projector in the chain. The connections are illustrated below.
2
1
3
120
DMX TERMINATOR
CONNECTION
Connect a 120 (OHM) resistor
across pins 2 and 3 in an XLR plug
and insert into the DMX out socket
on the last unit in the chain.
PIN 3
PIN 2
SETUP OPTIONS-PROJECTOR CONFIGURATION
UP
Projector configuration can be set conveniently via pressbutton switch and digital display. Turn the projector on and the
igital display will show DMX address you set and save last time and it can be reset and saved again as you please.
d
Press button UP or DOWN if you want to browse through the various Setup Options.
Press button ENTER to save your settings or enter the next menu. Press button UP or DOWN to shift
the display between
and
or change the display of address.
Press button FUNC, it will return to the upper menu one by one. The display will return automatically to the function of
address display if you stay for about 60 seconds defaulted.
TO SET THE DMX START ADDRESS
Each SOLO 575P must be given a DMX start address so that the correct projector responds to the correct control
signals. This DMX start address is the channel number from which the projector starts to “listen” to the digital control
information being sent out from the controller. The SOLO 575P have 16 channels, so set the No. 1 projector’s address to
01, No. 2 projector’s address to 017, No. 3 projector’s address to 033, No. 4 projector’s address to 049, and so on.
0
Launch the projector. Press button ENTER more than 5 seconds to unlock panel.
Press button FUNC to
;
Press button ENTER, it will display address;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm;
Press button FUNC, it will return to the upper menu one by one.
6/18
