4
●
There are safety cord holes at the bottom of the base of a projector. In view of safety, please run the safety
cord supplied through the safety cord holes for safety support.
●
Before any installation, maintenance and cleaning work, please ensure the projector is disconnected from
power mains.
●
After running for 30minutes, the temperature of the housing of the projector is
45
℃
.After stable operation ,
its temperature is
75
℃
.
●
While the lamp is stricken for the first time, there will be smoke and strange smell. It’s normal and does not
mean the projector has some defects.
●
Do not mount the projector directly on inflammable surface.
●
Do not project the beam straightly on combustible items and the minimum distance between the projector
and illuminated items is 18m.
●
A projector should be installed with good ventilation and the minimum distance between the projector and
walls is 50cm. At the same time, please ensure the fans and air inlets and outlets are workable.
2.
INSTRUCTIONS
●
CLEANING AND MAINTENANCE
If a projector can’t start. Please check if the fuse is blown up. If it does, replace it with a new fuse with same ratings. And the
projector has over-temperature protective device. If the temperature is too high, the protective device will be triggered to shut the
projector off. When it happens, please check if the fans run normally or fan shield is blocked by dust. After the issue is solved,
restart the projector.
The accumulation of oil, smoke and dust on the lens will compromise the light output. Cleaning a projector is very necessary to
ensure a reliable use of it. Cooling fans need to be cleaned every 15days. Internal lens, reflector and hot mirror need to be cleaned
periodically to optimize light output.
Cleaning frequency is to be decided by operations and its environment. Use soft cloth and normal detergent for glass for cleaning
work. It’s advised external optical system be cleaned every 20days and internal optical systems every 30/60days. Keep lens clean
and do not touch optical parts with bare hands.
Special note:
It’s normal phenomena that there will be mild water mist on the lens while the waterproof product is in use.
●
Before any maintenance and cleaning, please ensure the project is off the power.
●
Only qualified person is allowed to do maintenance.
●
During maintenance and before maintenance, the projector must be off power.
●
To avoid internal damage, sun light or other light mustn’t penetrate into the projector via front lens
whether it runs or not.
●
Do not use alcohol or other organic solvent to clean the housing to avoid damage.
●
Do not use any solvent with chemical elements to clean color filters or hot mirror.
●
LUBRICATION
To ensure smooth movement of gobos and zoom and focus lens, it’s advised rotators’ bearings and 2 sliding bars for zoom and
focus lens be lubricated every 2 months. High quality and high temperature lubricant/grease is advised..
●
TROUBLESHOOTING
PROBLEM
ACTION
The projector doesn’t switch on
Check the fuse on the power socket.
Check the lamp.
The lamp is on but the projector doesn’t respond
to the controller
Make sure that the fixture’s start address is right
Replace or repair the XLR signal cable.
The projector functions intermittently
Make sure the fan is working well or fans and their shields are not blocked
Beam appears dim, Low in brightness
Make sure the lamp is within its lifespan
