PR Lighting Mega Colour 2500, Руководство по эксплуатации продукта

Страница: 14 / 20

14/20
LED INDICATION
Green
On DMX signal OK
Off No DMX signal
Flash DMX signal error
Yellow On Setting the panel
Blue On Power
Red/Green
Red Running Slave mode or self test mode
Green Running Master mode
MAINTENANCE
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes damaged or deformed in
any way it must be replaced. If the light from the lamp appears dim this would normally indicate that it is reaching the end
of its life and it should be changed at once, If the projector does not function, check the fuses on the power socket of the
projector, they should only be replaced by fuses of the same specification. Should these be damaged call a qualified
technician before replacement. The projector has thermal protection device that will switch off the projector in case of
overheating, should either of these operate, Check that the fans are operational, if not call a qualified technician.
Any maintenance work should only be carried out by qualified technicians.
KEEPING THE PROJECTOR CLEAN
To ensure the reliability of the projector it should be kept clean. It is recommended that the fans should be cleaned every
15 days. The lens and dichroic colour filters should also be regularly cleaned to maintain an optimum light output.
Do
NOT use any type of solvent on dichroic colour filters.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoke or particularly dirty
surroundings can cause greater accumulation of dirt on the unit’s optics. A soft cloth and typical glass cleaning products
should be used in cleaning. It is recommended to clean the external optics at least once every 20 days and clean the
internal optics at least once every 30 / 60 days.
Do not use any organic solvent, e.g. alcohol, to clean the reflector mirror, dichroic colour filters or housing of
the apparatus.
TROUBLESHOOTING
PROBLEM ACTION
The projector doesn’t switch on
¾
Check the fuse on the power socket.
¾
Replace the lamp.
The lamp comes on but the projector
doesn’t respond to the controller
¾
Make sure that the projector is correctly configurated.
¾
Replace or repair the DMX cable.
The projector only functions intermittently
¾
Make sure the fan is working and not dirty.
Defective projection
¾
Check the lenses are not broken.
¾
Remove dust or grease from the lenses.
The project image appears to have a halo
¾
Make sure the lamp is installed correctly.
¾
Carefully clean the optical group lenses and the projector
components.
The beam appears dim
¾
Check the optics is clean.
¾
Replace with a new lamp of the specified type and rating.