9
5. SETUP AND CONFIGURATION
●
FRONT PANEL OPERATION
To browse through or change the projector ’s settings, press ENTER key for more than 3s(press ENTER key after power on) to
unlock the screen , then press
UP/DOWN
key to enter the projector ’s function menus. Each main menu has its sub-menus. And
each menu stands for special function. For the details, please see the following 6
th
point ”Operation Menu”.:
1.
At the page to set the fixture’s functions, press
UP
or DOWN key
to select the functions desired.
2.
While menu operations, the
FUNC
key to escape, and
ENTER
key is used to confirm. Press ENTER
key to save the changes
or enter into the sub menus. Press
UP
or
DOWN
key to change the numbers(minus or plus).
Press FUNC key to go to the uppler menu. If no key is pushed, the system will go back to initial status automatically..
●
DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The projector has 3DMX modes. There are standard mode ,short mode and extended mode. For example standard mode
has 26
c
hannels, so set the No. 1 projector’s address 001, No. 2 projector’s address 027, No. 3 projector’s address 053,No. 4
projector’s address 079, and so on.
Switch on the Projector . Press ENTER key more than 3 seconds to unlock panel, then press
UP or DOWN key to enter into the
fixture’s operation menus.
Select DMX Address icon and press ENTER key on the display and select DMX address at the 2
nd
level menu for the address setting.
Press
UP
or DOWN
key
for the DMX address desired.
Press ENTER key to confirm.
Press the FUNC key to go back to the upper level menu.
.
●
DMX WIRELESS CONTROL
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1. Press ENTER for more than 3s to unlock the control panel, then press
UP or DOWN key to enter into the operation
menu and select “Config Settings”.
2. Select “Wireless Only” from the menu of “Signal Select”.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it,
Press “Enter” for the menu of Un-link Wireless under the upper level menu of Config Settigns , then the fixture is unlinked
with the wireless transmitter.
DANGER!
Before replacement of gobos, the projector must be off the power.