8
图案片安装
滤色片安装
1
1
2
2
Lock the tilt and unfasten 4 fast fit screws of the chamber cover. Open the cover and you’ll see the structures as the figures above.
For the rotating gobos: remove the rotator by hand as the figure hereinafter in the sequences of1→2 ; remove the gobo after the
tightening spring for the gobo is taken out. Place a new gobo in the rotator and put back the spring. And ensure the spring is into the
narrow end of the rotator, i.e., inner ring of the rotator. At last, use a proper tool to pull the tightening clip and put the rotator back to
the wheel with the help of the other hand in the opposite sequences of removal
（
2→1
）
.
Note: Do not touch the color filters ,glass gobos with bare hand. There must be soft and clean paper or cloth between the hand and the
glass gobo. Tighten the 4fast fit screws after the cover is put back. Unlock the Tilt.
DANGER!
BEFORE THE REPLACEMENT OF GOBO AND COLOR FILTER, THE PROJECTOR MUST BE OFF
POWER.
5. SETUP AND CONFIGURATION
●
FRONT PANEL OPERATION
Projector configuration can be set conveniently via push button and LCD display.
Launch the projector and press button ENTER for more than 3 seconds to unlock the panel, the LCD will show the function menu of
the projector, each main menu has its submenus and each submenu has a specific function. For details, please see the
“OPERATION MENU” section.
Press button UP or DOWN if you want to browse through the various Setup Options.
Press button ENTER to save your settings or enter the submenu.
Press button UP or DOWN to change values(plus or minus)
Press button FUNC, it will return to the upper menu. If button FUNC not pressed, the default will show display status automatically.
●
DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The projector has 3 DMX modes. There are short mode ,standard mode and extended mode. For example standard mode
has 31
c
hannels, so set the No. 1 projector’s address 001, No. 2 projector’s address 032, No. 3 projector’s address 063, No. 4
projector’s address094, and so on.
Launch the projector. Press button ENTER more than 3seconds to unlock panel.
Press button ENTER to display DMX address;
Gobo Installation