PR Lighting AQUA 350E BWS, Руководство пользователя, Страница: 9 / 28

9/28
5. SETUP AND CONFIGURATION
●
FRONT PANEL OPERATION
Projector configuration can be set conveniently via push button and LCD display.
Launch the projector and press button ENTER for more than 3 seconds to unlock the panel, the LCD will show the function menu of
the projector, each main menu has its submenus and each submenu has a specific function. For details, please see the
“OPERATION MENU” section.
Press button UP or DOWN if you want to browse through the various Setup Options.
Press button ENTER to save your settings or enter the submenu.
Press button UP or DOWN to change values(plus or minus)
Press button FUNC, it will return to the upper menu. If button FUNC not pressed, the default will show display status automatically.
●
DMX START ADDRESS
Each projector must be given a DMX start address so that the correct projector responds to the correct control signals. This DMX start
address is the channel number from which the projector starts to “listen” to the digital control information being sent out from the
controller. The projector has 3 DMX modes. There are short mode
，
standard mode extended mode. For example standard mode has
26 c hannels, so set the No. 1 projector’s address 001, No. 2 projector’s address 027, No. 3 projector’s address 053, No. 4 projector’s
address079, and so on.
Launch the projector. Press button ENTER more than 3seconds to unlock panel.
Press button ENTER to display DMX address;
Press button UP and DOWN, you can set the address;
Press button ENTER to confirm; after powered on next time, the default will be last value saved
Press button FUNC, it will return to the upper menu
.
●
DMX WIRELESS CONTROL
The projector has wireless control function with wireless receiver module and antenna for remote control.
The setup of it is below:
1. Enter into the projector’s menu. Select the menu “Config Settigns” via the bottoms of UP and DOWN
2.
Select DMX control Mode ---- Wireless First (Note: Do not select XLR ONLY), then wireless indication in the
front panel will be on, meaning wireless control function is activated.
Only after the projector is linked with a transmitter, can it receive wireless signal sent by the transmitter. If unlinking it, Press
“Enter” for the menu of Unlink Wireless under the upper level menu of Config Settigns.