PPC ID-2000 Series, Руководство пользователя

Страница: 36 / 39

35
3. Instructions on Maintenance
3.5 Troubleshooting
1. In case front LED keeps on flashing or always on all the time.
Error Code Trouble Solution
10
11
12
13
14
15
16
17
TPH Module open
TPH temperature trouble
Encoder trouble in
ribbon control part
TPH Up/Down failure
Card jammed
Medium trouble
EEPROM trouble
IC Contact Module not
correctly positioned
- Check TPH module is closed
- With TPH module opened, check printer inside and
turn power off and on. Perform module Up/Down.
- Remove the jammed card inside the printer
- Check that temperature is within the operating
temperature range.
- Open TPH module and check that cable is correctly
connected.
- Check that ribbon is cut
- Check that ribbon run out.
- Check that encoder in ribbon control part is
correctly assembled and operates normal.
- Check that size of the medium meets specification
- If same trouble repeats, contact dealer.
- Turn power on again.
If same trouble repeats, contact dealer.
- Check that IC Contact Module is correctly positioned
- If not correct, turn power off and on.
- If same trouble repeats, contact dealer.
50˜51 Flipper module
communication trouble
- After remove card, turn power on.
- If same trouble repeats, contact dealer.
52˜56 Flipper module
mechanism trouble
- After remove card, turn power on.
- If same trouble repeats, contact dealer.
57
Flipper improperly
positioned or Card inside
- After remove card, turn power on.
After the trouble above is resolved, perform one of three below to
get printer into normal operation.
1) Press reset button with ribbon cartridge correctly loaded.
2) Press "EJECT" button
3) Place power switch in OFF position, and ON position.