6 PUCK-V1_PCL
Introduction
4
This User Guide provides information on the installation
instructions of the PUCK-V1 antenna.
Threaded Spigot Mounting
Use the Drill template below or download the 1:1 drill
template from http://www.poynting.tech/downloads.
•
Choose the mounting location carefully and a
position at least 50cm from heat sources, with a
clear line of sight to the sky.
•
Once you have decided on the location and
checked that there are no obstructions such as
cables or channels below the mounting surface,
for the fastening nut and cables to pass through,
use the downloaded 1:1 drill template to mark the
mounting location.
•
To prevent the marking tool or drill sliding off course,
use masking tape over the drilling point to help
hold the drill point in place. The masking tape also
prevents hot shavings from the drill or hole saw which
could penetrate and damage the painted surface.
•
Clean the entire surface on which you plan to mount
the antenna. Cleaning is done so as not to damage
the vehicle’s paint and to ensure good contact of
the foam surface to the mounting area.
•
Alcohol wipes can be used to remove oil and dirt
from the surface.
•
The 10mm Threaded Spigot should be used to
secure the antenna to a surface structure of 10mm
thickness or less. Likewise, the 50mm Threaded
Spigot should be used to secure the antenna to a
surface structure of 50mm thickness or less.
Securing the antenna
•
Fasten the required spigot with the Flat head screws.
•
Clean the plastic surface of the antenna base and
threaded spigot.
•
Peel off one of the wax paper layers from the foam
seal and stick the foam seal to the plastic surface.
•
Carefully slide the cable through the hole.
•
Peel off the second wax paper layer and firmly press
the antenna down onto the surface.
•
Tighten the nut so that it compresses the foam seal.
Note:
Be careful not to over tighten the nut.
Installation Instructions
5
www.ime.de
