DAILY / INTERVAL
1) The filter in the solution tank (FIG 3) should be kept clean. It can be removed if
necessary. A damaged filter should be replaced, otherwise blockages and/or
damage to the pump head and spray jet can occur.
2) Check the spray jet (FIG 4) for blockage and a uniform spray pattern.
Remove jet and blow through to clean. Do not use a pin or other sharp objects
as this may cause damage to the jet.
3) Check and remove any debris or lint build-up from the vacuum head, brush,
and brush housing.
4) Always wash out the tanks with clean water after use. To do this, pour clean water into
the solution tank and spray through spray tip to clear chemical residue from the pump,
lines, and spray tip. Allow the vacuum to run for a few minutes after use to aid the
machine in drying out and to help prevent bacteria and odors.
5) Wash out mesh filter in RECOVERY TANK of dirt and carpet fibers after dumping waste
from recovery tank. Failure to clean filter may cause damage to vacuum motor.
WEEKLY
1) Inspect hoses (unseen blockages sometimes occur), hose cuffs, and the rubber seal on the recovery tank lid. The main
cable, plug, and switches should also be examined for damage.
NOTE: It is advisable to store the unit with the recovery tank lid removed.
CAUTION: THIS UNIT MUST BE PROTECTED FROM FREEZING. Damage from freezing could cause machine to malfunction.
ROUTINE MAINTENANCE INSTRUCTIONS
STORAGE
WHEN CLEANING IS FINISHED:
1) Disconnect the SOLUTION HOSE on the front of the machine by pushing in on the ring of the solution fitting.
2) Connect the drain hose (clipped to the back) to the SOLUTION HOSE fitting and
place the other end into the RECOVERY TANK. Press the SOLUTION switch to the
“right” position. This will activate the motor to pump any remaining solution into
the RECOVERY TANK for easy drainage.
3) When all of the solution is pumped from the SOLUTION TANK, turn the SOLUTION
switch off, remove the power plug from the outlet and empty the RECOVERY
TANK. Leave the RECOVERY TANK open when storing.
4) Disconnect the DRAIN HOSE by pushing in on the ring of the SOLUTION HOSE
fitting. Replace the DRAIN HOSE in the clip on the back of the machine, and re-
connect the SOLUTION HOSE.
FIG. 2
FIG. 3
FIG. 4
SOLUTION SPRAY JET
– 7 –
GENERAL INSTRUCTIONS
Содержание PFX3S
Страница 4: ...4...