801531
Correct Installation Rules:
1. All lines into the system must be protected with the appropriate Telco/data protection module.
2. The maximum number of snap-in modules on one AC protector (with a power cord) is six. Four modules on a wall plug-in AC
protector.
3. The use of extension cords plugged into an AC protector or an AC protector plugged into an extension is forbidden.
4. All equipment within the same protection zone must be plugged into the same AC surge protector. (See diagram below)
5. The AC surge protector must be plugged into a grounded AC outlet. The lack of ground is indicated by a red light on the surge
protection device. Refer to installation diagram for proper procedure.
Connected Network Equipment Warranty Information
Claims Procedure:
1. Any claim under the Connected Equipment Warranty must be made within 10 (ten) days of the date of the alleged damage to the
connected equipment.
2. Call Powerware customer service department at 800-554-3448 #4 for a Return Authorization (RA) number and your claims
information package.
3. Return the suppressor(s) that was connected to the damaged equipment, the original purchase documentation and your
completed claims information package within 30 days, freight prepaid to:
Warranties Division, 4300 Fortune Place, Suite A, West Melbourne, FL 32904
4.
Important.
Clearly mark the RA number you were given on the box you are returning.
5. After determining that the product has been damaged from AC power line transients, Powerware will either authorize you to
have the equipment repaired or reimburse you for the fair market value of the damaged equipment not to exceed $25,000.
No employee of Powerware or any other party is authorized to make any representation beyond those made in this agreement
concerning the Connected Equipment Warranty.
SERVER
19 INCH CABINET
NETWORK HUB
ZONEBARRIER - Modem/DSU
and HUB Port Protection
PATCH PANEL
SNAP-IN Network
Port Protection
ZONEGUARDIAN
A/C Protection
HUB, PC, Modem/DSU Protection
MODEM
PowerGuardian
A/C Protection
Terms and Coverage provided by the Connected Equipment Warranty:
Period of Coverage
— Coverage for hardware damage is provided up to the last day of the surge protector product warranty.
Coverage Limitation —
Hardware:
Hardware coverage is limited to repair or replacement cost of properly connected protected equip-
ment per occurrence up to a limit of $25,000.
Coverage Exclusion
— Hardware damage associated with any cause other than transient voltage surge (power abnormalities) is ex-
cluded. Damage associated with equipment modification or improperly protected equipment is not covered. Damage associated with
flood, fire, liquid spills, earthquakes, war, insurrection, vandalism, theft, normal use, wear and tear, erosion, abuse is not covered. Corrup-
tion of software or data is not covered.
The surge protection device must have perceivable damage as determined by Powerware. Powerware reserves the right to audit damage,
site and/or cost of repairs. The Connected Equipment Warranty is valid
ONLY
if equipment is correctly installed.
