PowerTek PowerBeam ACD039, Инструкция по эксплуатации

Страница: 5 / 8

Model No. ACD039
VEHICLE JUMP START INSTRUCTIONS:
WARNINGS:
Review your vehicle owner’s manual instructions before attempting to jumpstart your vehicle. Failure to
follow these advisory instructions may result in personal injury and property damage. Use safety glasses
to protect your eyes while working near a battery during vehicle jump-starting. Jump start a vehicle
in an open area without any type of obstructions.
1. Turn off the vehicle ignition and all accessories (Such as radios, lights, and air conditioners, etc).
2. Apply the emergency brake and put those vehicles with automatic transmission in park position.
3. Determine the polarity of the vehicle battery terminals. The positive (+) battery terminal normally is
larger in diameter than the negative (-) terminal. If you are unsure, you must refer to the vehicle
owner’s manual.
1. Determine whether your vehicle is equipped with a negative or positive grounded system: Most
vehicles use this type of system. Positive Grounded battery terminal is grounded to chassis or any other
part of the vehicle. If you are not certain of this important information, YOU SHOULD REFER
TO YOUR VEHICLE OWNER’S MANUAL.
2. Remove clamps from the holders. Never allow clamps (positive & negative terminals) to touch
together or contact the same piece of metal to prevent short-circuits.
3. Follow the instructions for a negative grounded system or positive grounded system as indicated
below:
Negative Grounded System
Connect the RED CLAMP (positive +) to the positive terminal of the vehicle battery or the remote
positive terminal if available.
Connect the BLACK CLAMP (negative -) to the vehicle engine block, or a metal part of the vehicle which
is connected to the vehicle main ground system. Do not clamp directly to negative battery terminal, main
fuel distribution module or sheet metal parts.
The Polarity Protection System GREEN LED is illuminated if the proper connections have been made.
WARNING: If RED LED is illuminated, DISCONNECT the booster clamps from battery terminals.
Reconnect the booster clamps by reversing the connections to the proper battery polarity.
Sheet
5
of
8