Thank you for purchasing the Marine Battery Charger. Our products have been designed and manufac-
tured to meet the harsh environmental, mechanical and electrical conditions that are present in the
marine industry. We are happy to introduce you our battery charger, boasting a clean geometric design
executed with a heavy duty extruded aluminum housing thus roviding increased power and performance.
Your battery charger incorporates digitally controlled performance charging technology proven to fully
charge and extend the life of your batteries.
All-Digital Technology for Enhanced Performance
Microprocessor and software controlled pulse charging technology helps to deliver
cooler charging process and faster charging.
Fully Automated Multistage Digital Charging
Involves 5 stages, such as analyzing, charging, examining the conditions, auto maintaining and
reconditioning batteries once a month. This 5-stage charging method helps to fully charge and extend
your battery life. As well as provide safe operation for both short and long term storage periods.
Digital Charging Monitoring
Monitors charging level progress during the charging operation. Single red LED
indicates charging low battery(s).
System Check OK Indication
During AC power-on, the battery charger analyzes and confirms with the System Check OK indicator
that the charger is wired correctly, batteries are greater than 2.5 VDC and are able to be charged.
Battery Fault Detection
Avoids time consuming troubleshooting and clearly indicates wiring faults of each
battery or if a battery is less than 2.5 VDC and unable to accept charge.
LED Charging Display
Highly visible AC Power and status LEDs indicating the progress of each 5 modes,
such as Initalizing, fast charging, optimizing, maintaining and smart storage.
Integrated Highly Efficient output distribution Technology
We have designed our battery chargers to automatically sense and provide 100% of
available charging amps to any or all of the banks as needed. All unused charging amps
are Distributed- On-Demand™ to batteries on board that require additional charging amps.
Energy Saving Mode
After batteries are fully charged and conditioned, the charger will observe and auto maintain
batteries only if needed to maintain a full state of charge. This reduces remarkably AC power
consumption and lowers operating costs while maximizing the battery performance.
High Quality and Safety
Heavy duty extruded aluminum housing and In-line DC fuses for all battery banks. Over-volt-
age, overload, over-temperature, reverse polarity and ignition protection. Designed and
assembled to meet the requirements of SAA C-Tick certificate
Easy Setup and Operation
Pre-wired with 6 feet AC and DC cables
1-Year Warranty
Applicable only if the charger has been operating with 12 volts Flooded and AGM
Lead Acid batteries.
Introduction
1
MAINTENANCE
Item:
AC Power Cord
Process: Visually inspect the AC power cord. Confirm ground blade is present
and all plug blades are in good condition and not bent out of place.
When: Monthly
Item:
Mounting Hardware Inspection
Process: Check all mounting hardware to ensure there is no loose hardware.
Tighten where required.
When: Monthly
Item:
Battery Connections
Item:
Battery Electrolyte
Process: Clean and tiqhten all battery connections. Follow battery
manufacturer’s instructions for cleaning a battery, Clean all battery
terminals with a wire brush where required and tighten all battery
connections
When: Monthly
Process: Per battery manufacturer’s instructions,monitor, and maintain proper
levels of distilled waterin each battery.
When: Monthly
Item:
DC Output Wiring
Process: Visually inspect all wining for cuts and abrasions. Contact us if your
charger needs to be serviced.
When: Monthly
22
